Panduan Pewarnaan Bagian Nylon Profesional dengan Markforged: Langkah demi Langkah
Prosedur Pewarnaan Bagian Nylon Markforged
Oleh Christopher Hayes, Special Aerospace Services
Sama seperti Model T membuka jalan untuk kustomisasi warna mobil, Mark One Markforged memungkinkan Anda membuat bagian nylon dalam hampir semua warna yang Anda inginkan—dengan syarat bagian putih, atau diubah oleh warna penguat komposit.
Markforged menawarkan empat kombinasi warna dasar dari nozzle:
Putih – nylon polos
Putih & Emas – nylon reinforced with Kevlar®
Putih & Putih – nylon reinforced with fiberglass
Putih & Hitam – nylon reinforced with carbon fiber
Kombinasi ini ideal untuk rapid prototypes dan functional parts, tetapi finished goods seringkali membutuhkan richer hues. Dyeing menawarkan cost-effective, scalable solution.
Why Nylon Is Ideal for Dyeing
Nylon’s hygroscopic nature means it readily absorbs moisture, which can both weaken and, when controlled, soften the material. Submerging printed parts in water permanently reduces brittleness, increases flexibility, and allows water-soluble dyes to penetrate and lock in color.
We recommend liquid RIT dye (post‑2011 formula) for its affordability, availability, and consistent color performance. Light dyes benefit from thicker walls, a reinforced ceiling, and extended dyeing time to avoid visible carbon‑fiber strands, as seen in the HALO Wallet example.
Step‑by‑Step Dyeing Process
Place the printed nylon parts in a double‑layer Ziploc bag and submerge them in near‑boiling water (≈100 °C) for 30–60 minutes. Use pot holders to protect yourself from hot water.
Transfer the parts to a new inner bag containing a 5:1 ratio of water to RIT dye. Seal the bag, remove trapped air by folding over a table edge, and gently agitate the mixture.
Fill the outer bag with near‑boiling water, seal, and allow the parts to soak for another 30–60 minutes. Agitate occasionally to ensure even color distribution.
If a deeper hue is desired, reheat the mixture in 30‑second microwave intervals and add additional dye. Avoid microwaving carbon‑fiber‑reinforced parts.
After dyeing, rinse the parts thoroughly with clean water. Allow 6–12 hours for complete drying before handling or using the parts, especially when dark dyes are involved to prevent leakage during twisting or squeezing.
Success example: Bright yellow key carabiners (note: these are not rated for climbing).
